Wrougth Iron Fence

by The Bugking

I made 2.5” of this in about 30 minutes.

Materials needed

• Half Round Plastruct
• H beam Plastruct
• Channel Plastruct
• Square Plastruct
• Brass Rod
• Plastic Cement
• Cyanoacrilate Glue

Tools Needed

• Pin vice (Or dremel.  A dremel would knock of 5 minutes any way)
• Exacto Knife
• Ruler
• Wire Cutters

Gather the plastruct needed.



Measure out your vertical member spacing in the Channel and H beam.(I was a bit sloppy.  Use a pen for better effect.  The more accurate you are the better the final result will look.)



Drill out holes on the centers marked.



Glue the half round to the channel so that the legs are down.



Cut your vertical members out of brass rod.  These are approximately 1” long.



Glue the vertical members into the channel piece with CA glue first.  You may find it easier if you do the extreme ends first and then put on the H beam.  Do not apply glue to the H beam until all the vertical members are in place. The CA glue will bond to the rod very quickly.



Cut two end pieces out of the square rod.  Then trim one end down to a blunt point.



Glue the end pieces on.  It is a good idea to test fit them first.  The rails may need to be trimmed.



Trim the vertical members so that they are slightly shorter then the end pieces.



The Bugking